Power Brad Nailers

OPERATIONAL ISSUES​​

​​Q: Why aren’t my fasteners driving fully?​​
❗ Symptoms: Fasteners protrude or fail to sink.

• ​​Possible Causes​​:
  1. Insufficient drive depth adjustment.
  2. Low cylinder air pressure (pneumatic models).
• ​​Solutions​​:
  → Adjust the drive depth knob clockwise.
  → Recharge the cylinder to the rated pressure (check tool specifications).

​​Q: Why are fasteners driven too deep?​​
❗ Symptoms: Surface damage or over-sunk fasteners.

• ​​Possible Cause​​: Excessive drive depth setting.
• ​​Solution​​:
  → Turn the depth knob counterclockwise and test on scrap material.

---

​​POWER & BATTERY ERRORS​​

​​Q: Why does the tool not start when I squeeze the trigger? (No LED)​​
❗ Critical checks:

• ​​Possible Causes​​:
  1. Power switch off.
  2. Dead/improperly connected battery.
  3. Burnt-out battery or internal damage.
• ​​Solutions​​:
  → Ensure the power switch is ​​ON​​.
  → Remove and reinsert the battery until it clicks.
  → Replace old batteries (dispose of properly).
  → Contact Energiguru Tools if internal damage is suspected.

​​Q: Why does the LED flash twice when I pull the trigger?​​
❗ Indicates: Low battery charge.

• ​​Solution​​:
  → Replace with a fully charged battery.

​​Q: Why does the LED flash 6 times?​​
❗ Warning: Overheating detected.

• ​​Solution​​:
  → Let the tool/battery cool for 15+ minutes before resuming.

---

​​JAMMING & MECHANICAL FAILURES​​

​​Q: Why does the tool jam frequently?​​
❗ Common triggers: Dirty magazine or incorrect fasteners.

• ​​Possible Causes​​:
  1. Mismatched fastener type/size.
  2. Loose/dirty magazine.
  3. Damaged fasteners.
• ​​Solutions​​:
  → Verify fastener specifications match the tool.
  → Tighten the magazine screws and clean debris.
  → Replace bent or corroded nails/staples.

​​Q: Why does the LED flash 3 or 4 times?​​
❗ Severe alert: Motor/gear overload or high air pressure.

• ​​Possible Causes​​:
  1. Air pressure exceeding 0.6MPa (pneumatic).
  2. Motor/gear seizure.
• ​​Solutions​​:
  → Reduce air pressure to rated levels.
  → ​​Stop immediately​​ and contact Energiguru Tools.

---

​​SAFETY WARNINGS​​ ⚠️

​​Q: What must I do before servicing the tool?​​

• ​​Mandatory Steps​​:
  1. Disconnect battery/charger power.
  2. Allow overheating tools (>60°C) to cool for 30+ minutes.
  3. Never force the tool if abnormal noises/vibrations occur.

​​Q: How to handle a stuck workpiece contact?​​

• ​​Solution​​:
  → Ensure the contact arm rebounds freely; clean or lubricate if stiff.

---

​​! WARNING​​
Always follow these precautions:
➔ ​​DISCONNECT POWER SOURCES​​ before maintenance.
➔ Use ​​gloves and eye protection​​ when clearing jams.
➔ Dispose of damaged batteries at certified recycling points.

For unresolved issues, contact ​​Energiguru Tools Support​​: info@energiguretools.com